By Jerold Bell, DVM
Tufts University School of Veterinary Medicine, N. Grafton, MA
This article was presented at the AKC Canine Health Foundation 2001 National Parent Club Health Conference, and appeared in the “Healthy Dog” section of the November 2001 AKC Gazette.
With each new generation of dogs, breeders ask, “How can I continue my line and improve it?” Aside from selecting for conformation, behavior and ability, breeders must consider how they are going to reduce the incidence of whichever genetic disorders are present in their breed. There are no answers that will fit every situation. There are, however, guidelines you can follow to preserve breeding lines and genetic diversity while reducing the risk of producing dogs that carry defective genes, or are affected with genetic defects.
Autosomal Recessive Disorders
In the case of a simple autosomal recessive disorder (in other words, a disorder caused by a single, recessive gene that is not sex-linked) for which a test for carriers is available, the recommendation is to test your breeding-quality stock, and breed carriers to normal-testing dogs. The aim is to replace the carrier breeding-animal with a normal-testing offspring that equals or exceeds it in quality. You don’t want to diminish breed diversity by eliminating quality dogs from the gene pool because they are carriers. As each breeder tests and replaces carrier dogs with normal-testing dogs, the problem for the breed as a whole diminishes. (See “The Effects of Genetic Testing: Constructive or Destructive?” in the “Healthy Dog” section of the June 2001 AKC Gazette.)
For some disorders there are tests known as linkage-based carrier tests, which can generate a small percentage of false positive and negative results. When using these tests to make breeding decisions, it’s advisable to first determine whether the results correlate with the test results and the known genotypes of relatives.
When dealing with a simple autosomal recessive disorder for which no carrier test exists, breeders must assess whether each individual dog in their breeding program is at high risk of being a carrier. This requires knowledge of the carrier or affected status of close relatives in the pedigree. An open health registry that is supported by the parent club makes it easier for breeders to objectively assess these matters. By determining the average carrier-risk for the breeding population, breeders can select matings that have a projected risk which is lower than the breed average.
If breeding a dog that is at high risk of being a carrier, the best advice is to breed to a dog that has a low risk. This will significantly diminish the likelihood that affected dogs will be produced, and can reduce by up to half the risk that there will be carriers among the offspring. Using relative-risk assessment as a tool, breeders should replace higher-risk breeding dogs with lower-risk offspring that are equal to or better than their parents in quality. Relative-risk assessment allows for the continuation of lines that might otherwise be abandoned due to high carrier risk.
Breeding a dog only once and replacing it with an offspring allows breeders to improve their chances of moving away from defective genes and also limits the dissemination of defective genes. When dealing with disorders for which carriers cannot be identified, the number of offspring placed in breeding homes should be kept to a minimum.
Autosomal Dominant Disorders
Autosomal dominant genetic disorders are usually easy to manage. Each affected dog has at least one affected parent, but it can be expected that half of the offspring of an affected dog will be free of the defective gene. With disorders that cause death or discomfort, the recommendation is to not breed affected dogs. To produce the next generation of a line, a normal full sibling of an affected dog can be used, or the parent that is normal can be used.
A problem with some autosomal dominant disorders is incomplete penetrance. In other words, some dogs with the defective gene may not show the disorder. Roughly half their offspring, however, may be affected. If a genetic test is available, this is not a problem. Otherwise, relative-risk assessment can identify which dogs are at risk of carrying incompletely penetrant dominant genes.
For sex-linked (also known as x-linked) recessive defective genes for which carrier tests exist, breeders should follow the same “breed and replace” recommendations as are outlined above in the discussion of autosomal recessive disorders. If there is no test, the defective gene can be traced through the pedigree. If a male is affected, he would have received the defective gene from his carrier mother. All of his daughters will be carriers, but none of his sons. By using relative-risk assessment to breed him to a female that is at low risk of being a carrier, you can prevent affected offspring, and select a quality son for replacement.
There are rare instances in which a female is affected with a sex-linked disorder. In such cases, she would have received the defective gene from both parents; specifically, an affected father and a mother who is either a carrier or is affected herself. If an affected female is bred, all the sons will be affected, and all the daughters would be carriers, so affected females clearly should not be bred. A normal male that is a littermate to an affected female, however, would be able to carry on the line without propagating the defective gene. Sex-linked dominant disorders are managed the same way as autosomal dominant disorders are. The difference is that affected males will always produce all affected daughters.
Polygenic disorders are those caused by more than one pair of genes. Most polygenic disorders have no tests for carriers, but they do have phenotypic tests that can identify affected dogs. (For a detailed discussion of polygenic disease management, see “Choosing Wisely” in the August 2000 AKC Gazette.)
With polygenic disorders, a number of genes must combine to cross a threshold and produce an affected dog. These are known as liability genes. In identifying a dog’s liability for carrying defective genes for a polygenic disorder, the breadth of the pedigree (that is, consideration of all siblings of individuals in the pedigree) is more important than the depth of the pedigree (consideration only of parent-offspring relationships.) A clinically normal dog from a litter that had one or no individuals affected with hip dysplasia (which is a polygenic disorder) is expected to carry a lower amount of liability genes than a dog with a greater number of affected littermates. This is why it is important to screen both pet and breeding dogs from your litters for polygenic disorders. Information on the siblings of the parents of potential breeding dogs provides additional data on which to base your breeding decisions.
Genetic disorders without a known mode of inheritance should be managed in the same way as polygenic disorders. If there are multiple generations of normalcy in the breadth of the pedigree, then you can have some confidence that there is less risk that liability genes are being carried. If a dog is diagnosed with a genetic disorder, it can be replaced with a normal sibling or parent and bred to a mate whose risk of having liability genes is low. Replace the higher-risk parent with a lower-risk offspring that equals or exceeds it in other aspects, and repeat the process.
Genetic tests are extremely useful tools to help manage genetic disorders. Even when there is no test, or a known mode of inheritance, much can still be done to reduce the incidence of affected and carrier animals. The use of these guidelines can assist breeders in making objective breeding decisions for genetic-disease management, while continuing their breeding lines.